51 52
channel is free for you to answer. Press the call key [PTT] to answer. If
there is no voice activity during the preprogrammed group call hang-up
time, the call is terminated.
Single call from contact lis
1. Press [MENU] key to enter the menu mode.
2. Press [ ]/ [ ] key to contact list, then press [MENU] key to select,
the items are arranged in alphabetical order.
3. Press [ ]/ [ ] to the desired user alias or ID.
Or press [ ]/ [ ] key to dial manually, then press [MENU] key to
select. If there is a user alias or ID dialed previously, the ID is displayed
with the blinking cursor and the keyboard is used to edit this ID.
Or press [ ]/ [ ] key to dial manually, then press [MENU] key to
select, use keyboard to input a new ID.
4. Hold the walkie talkie in its upright position and keep it at a distance of
1 to 2 inches (2.5 to 5.0 cm) from the mouth.
5. Press [PTT] key to initiate a call, LED indicator light is red. The first
line shows the user's alias or ID, the second line shows the single and
single call icons.
6. Release the [PTT] key to answer. When the radio responds, the radio
LED lights up green and the screen displays the ID of the transmitting
user.
7. If the "Channel Idle Tone" feature is enabled, when the target radio
releases the [PTT] key, you will hear a short beep indicating that the
channel is free for you to answer. Press the call key [PTT] to answer. If
there is no voice activity during the preprogrammed single call hang-up
time, the call is terminated.
8. You will hear a short tone; the screen shows the termination of the call.
If you release the PTT key while the walkie talkie is setting up a call, it
exits without any hint and returns to the previous screen. walkie talkies
can be preprogrammed to perform walkie-talkie presence detection prior
to setting up a single call. If the target walkie talkie does not answer, you
will hear a short beep, and the other party does not answer on the
screen. The walkie-talkie returns to the menu before starting the walkie
talkie presence test.
SMS Function
This product supports DMR data function, and allows sending and
receiving messages; the maximum length of each message is 144
characters. And SMS lines cannot be more than 50 lines.
Edit and Send Messages
Use the MENU function:
1.Press the [MENU] button to enter into the [MENU] mode.
2.Press the [ ]/ [ ] button, Select “Message “,press the [MENU]
button to select.
3.Press the [ ]/ [ ] button, Select “New Message” , press the
[MENU] button to select.
4.When blinking cursor appears, input the SMS by the keyboard, press
the [ ]button to move to left one, press the [ ] button to move to
right one.press [ BACK ]button to delete any useless character when
there are contents in the edit area, or else it will return to the upper menu
when there is no content in the edit area.
To Next Page
Loading...
