45 46
> For single call contacts, you can initiate single call, send text message,
and initiate extended function. Extended functions include: call prompt,
radio detection, remote monitor, activation, and remote kill.
Call prompt
In digital mode, you can send call prompt to a contact, and the other
party can call back directly
This feature is only available for user aliases or IDs, and can be
accessed via the menu via Contacts or Manual Dialing.
Initiate a call prompt from the communication list
1.Press [MENU] key to enter the menu mode.
2. Press [ ]/[ ] key to contact list, then press [MENU] key to select
3. Press [ ]/[ ] tkey to the desired user alias or ID, then press
[MENU] key to select.
Or press [ ]/[ ] tkey to manually dial, then press [MENU] key to
select, flashing cursor appears, input the user ID you want to call, then
press [MENU] key.
4. Press [ ]/[ ] tkey to “call alert” , the screen displays the call
prompt: <User alias or ID>, and then press the [MENU] key to indicate
that the call has been sent.
5.When the walkie talkie send a call prompt, the LED indicator light is
red.
6.If you receive a call confirmation, a tone sounds and a call alert
appears.
Or if no call alert confirmation is received, a beep sounds and the screen
displays a call alert failure.
Receive and confirm call prompt
When you receive a call alert, the screen displays a call alert, alternating
with the alias or ID of the calling walkie-talkie.
1. You will hear a repeat tone. The LED flashes red.
2. Press and release the [PTT] key to confirm the prompt, or press the
[MENU] key to select "Ignore?" To ignored the call prompt.
Radio detection
In digital mode, you can initiate radio detection to a contact without
interfering with each other to confirm whether the other party has turned
on the unit or uses in the current channel.
Initiate radio detection
User menu function：
1. Press [MENU] key to enter the menu mode
2. Press [ ]/[ ] key to contact list, then press [MENU] key to select
3. Press [ ]/[ ] key to the desired user alias or ID, then press
[MENU] key to select.
Or press [ ]/[ ] key to manually dial, then press [MENU] key to
select, flashing cursor appears, input the user ID you want to call, then
press [MENU] key.
4. Press [ ]/[ ] key to “Radio Check” , the screen displays the
radio check <User alias or ID>, and then press the [MENU] key to
indicate that the call has been sent.
5. When the walkie talkie send radio detection, the LED indicator light is red.
6. If the target walkie-talkie is active in the system, a prompt is emitted
and the screen briefly shows “Radio check success” .
To Next Page
Loading...
