Baofeng DM-1801 - CTCSS; CTCSS encode; CTCSS decode; Radio information query

86 87
CTCSS
CTCSS can be set only under the simulated channel, includes:
■ CTCSS encode ■ CTCSS decode
CTCSS encode
The menu functions as follows:
1.Press [MENU] to enter menu mode.
2.Press [ ]/ [ ] to set, then press [MENU] to select.
3.Press [ ]/ [ ] to the radio configuration, then press [MENU] to
select.
4.Use the keyboard to type the correct radio configuration password
(software Settings), then press [MENU] to select.
5.Press [ ]/ [ ] to CTCSS, then press [MENU] to select.
6.Press [ ]/ [ ] to CTCSS encode, then press [MENU] to select.
7.The screen shows “OFF” or a group of CTCSS decode number, press
[ ]/ [ ] to close or select CTCSS decode number .
·The keyboard can also be enter manually.
·Press [*] key to switch to DCS, [ ]/ [ ] key to select DCS code,
press [#] key to switch between positive phase (N) and negative phase (I)
8.Then press [MENU] to select, which already set the corresponding
CTCSS decode value, the screen displays CTCSS encode XX.
CTCSS decode
The menu functions as follows:
1.Press [MENU] to enter menu mode.
2.Press [ ]/ [ ] to set, then press [MENU] to select.
3.Press [ ]/ [ ] to the radio configuration, then press [MENU] to
select.
4.Use the keyboard to type the correct radio configuration password
(software Settings), then press [MENU] to select.
5.Press [ ]/ [ ] to CTCSS, then press [MENU] to select.
6.Press [ ]/ [ ] to CTCSS decode, then press [MENU] to select.
7.The screen shows “OFF” or a group of CTCSS decode number, press
[ ]/ [ ] to close or select CTCSS decode number .
·The keyboard can also be enter manually.
·Press[*] key to switch to DCS, [ ]/ [ ] key to select DCS code,
press [#] key to switch between positive phase (N) and negative phase (I)
8.Then press [MENU] to select, which already set the corresponding
CTCSS decode value, the screen displays CTCSS encode XX.
Radio information query
Check the relevant information of this product, including: the radioModel
information, serial number, CPS version, hardware version, firmware
version, DSP version, programming time, etc information.
You can go back to the previous screen at any time by pressing[BACK].
Check radio ID
The menu functions as follows:
1.Press [MENU] to enter menu mode.
2.Press [ ]/ [ ] to set, then press [MENU] to select.
3.Press [ ]/ [ ] to the radio setting, then press [MENU] to select.
4.Press [ ]/ [ ] to the radio number, then press [MENU] to select.
5.The screen shows the radio ID and name.This information can only be
accessed but cannot be modified