(2) Stop the engine
First set the engine on idle running for five minutes, so as to cool the engine
gradually, and then turn off the ignition switch, so the engine is stopped to work.
Notice：
．While the engine running, does not turn the start switch to “START” position, or it
will damage the starting motor.
．Do not keep the start switch at the “ON” position while the engine is shut down.
This will result in battery discharge.
4. Shipping, loading and unloading, slinging and towing of forklift truck
(1) Ship the forklift truck
(a) Apply the parking brake when shipping the forklift trucks by container or freight
car.
(b) Fix the mast and the balance weight with steel wire and use jacks to prevent the
forklift trucks from moving in the cabin.
(c) Pay attention to the overall length, width, height when loading, unloading and
shipping and conforming the regulations is necessary.
(d) Single transporting if necessary after disassembling the mast and balance
weight.
Notice:
Dismantling and slinging the component shall not be performed without the
approval of our company. Under special circumstances, the appointed sling position
should be used. The balance weight, fork and mast of the forklift truck all have their
appointed sling position. The above-mentioned data is only for a reference, which
may be adjusted because of configuration or technology optimization.
To Next Page
Loading...