R5900025 /08 ClickShare CSE-20030
3.1 Activating the base unit
About power mode
The Base Unit is powered via an external power adapter. Once connected, the Base Unit is automatically
switched in standby mode. For more information about power connection, see CSE-200's installation manual.
Standby button
1. Push the button shortly.
When the Base Unit was on, it goes to standby
When the Base Unit was in standby, it starts up.
3.2 Basic Use
Basic functionality
When entering a meeting room equipped with ClickShare and if the display is not in screensaver mode, the
ClickShare wallpaper is shown on the display. The content of the wallpaper depends on the setup.
Starting to use ClickShare is now very simple.
To start using ClickShare
1. Take a Button and Insert the Button into a USB port of your laptop. When necessary, use a USB convertor.
Getting started
To Next Page
Loading...
