Barco ClickShare - Getting Started; Powering the Base Unit on and off

3. Getting Started
3. GETTING STARTED
Overview
• Powering the Base Unit on and off
•BasicUse
• Advanced Use
• Use of an iOS device with ClickS hare Link
• User Interface
• Capture more
• Shared desktop: primary - extended
•Audioconfiguration
• Pairing
3.1 Powering the Base Unit on and off
About power mode
You can power on and off the Base Unit and bring the system in s tandby mode. In standby mode the system m utes the ou tput signal
to the display. If yo ur display s upports this, it will au tomatically enter pow er saving mode.
To power on the Base Unit or awake i t from standby
1. When the Base Unit is s hut down, s et the rocker switch at the back of the B ase Unit to “I”.
Refer to image 3-1.
Image 3-1
Rocker switch
2. If the system does not start up automatically, push the standby button shortly.
Refer to image 3-2.
R5900001 CLICKSHARE 22/12/2014
11