R5910888 /00 G6044
Image is not an even rectangle
• Perform keystone correction by pressing the “Keystone H“ and “Keystone V“ button on the remote control,
or using “Screen > Geometric Correction > V. Keystone or “H. Keystone” from the OSD menu.
Image is reversed
• To reverse the image, enable rear projection by selecting “Screen > Rear Projection > On” from the OSD
menu.
The projector stops responding to all controls
• If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before
reconnecting power.
If the remote control does not work
• Check if the operating angle of the remote control is pointed within ±30° (front and back) to the remote
receivers on the projector. Make sure there are any obstructions between the remote control and the
projector.
• Check the remote batteries. Make sure batteries are inserted correctly. Replace the batteries if they are
used up.
• Ensure you have set the correct IR code to the remote control. See “Remote Settings“ in the chapter
“Options Menu”, page 36.
Troubleshooting
To Next Page
