3. Display installation
2. Attach the display firmly to the VESA mounting bracket with 4 screws M4 x 10 mm. You should mount
the display in portrait position. Landscape position is not supported.
3.3 Conn ecting the sign al cables
CAUTION: Only connect one of the two video links . Connecting both inputs simultane-
ously will result in driver errors.
To connect the signal c ables to the display:
You may connect the display to a display controller by using the DVI or the DP connection. The active
input can be selected in the OSD menu.
1. Remove the cable cover. To remove t his cover push
the lock clips inside the top of the cover and gently
slide the cover upwards on the shaft. It may be needed to tilt the displays if the arm is blocking the
movement of the cover.
1
2
2. Remove the connector compartment cover. To remove the cover, gently push the two lips on top of the
cover, pull the top of the cover slightly away from the display and lift t he cover upwards.
K5902035 MAMMO TOMOSYNTHESIS 07/12/2017
11
To Next Page
Loading...
