5. Advanced operation
5. ADVANCED OPERATION
5.1 OSD menu position
About the OSD menu position
By default, the OSD menu comes up in the bottom center position of the screen. This position can be
modified however. There’s choice from a number of predefined positions.
To change the position of the OSD menu:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > User Interface > Menu menu.
3. Enter the Position submenu.
4. Select one of the available OSD menu positions and confirm.
5.2 OSD menu language
About the OSD menu language
By default, the OSD menu comes up in English. However, there’s a wide range of other languages avail-
able for the OSD menu of your Mammo Tomosynthesis.
To change the language of the OSD menu:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > User Interface > Menu menu.
3. Enter the Language submenu.
4. Select one of the available languages and confirm.
5.3 OSD m enu autom atic close functi on
About the OSD menu automatic close function
By default, the OSD menu will disappear automatically after approximately 90 seconds of inactivity. How-
ever, this function can be disabled so that the OSD menu remains on the screen until manually closed.
To enable/disable the OSD menu automatic close function:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > User Interface > Menu menu.
3. Enter the Automatic Close submenu.
4. Select Enabled/Disabled as desired and confirm.
K5902035 MAMMO TOMOSYNTHESIS 07/12/2017
23
To Next Page
Loading...
