3. Display installation
6. Plug the keyboard light mini-jack connector in the display’s +5 VDC power output connector located
next to the 24 VDC power outlet..
7. Adjust the light by means of the knob at the side of the keyboard l
ight.
3.8 F irst time starting up
Overview
You are now ready to start up your Mammo Tomosynthesis for the first time.
1. Switch on your Mammo Tomosynthesis as described in "Standby switching", page 20.
2. Turn on the computer connected to your display.
If you have properly installed your display and display controller, the Windows start-up messages will
appear once the boot procedure is finished.
Your Ma mmo Tomosynthesis will be running in a basic video mode at a default refresh
rate when first time starting up
. If you are using a Barco display controller, please con-
sult the user guide delivered with it to install the drivers, software and documentation.
When this is done, your display will automatically detect the connected video input sig-
nal(s) and apply the correct video mode and refresh rate.
K5902035 MAMMO TOMOSYNTHESIS 07/12/2017
17
To Next Page
Loading...
