4. Daily operation
When the display is switched on,thepowerLEDisblue. When the display is in stand-by mode,the
power LED is orange.
The power LED can be disabled in the OSD menus. Please refer to "Power status indi-
cator light", page 24 for deta iled instructions on how to do this.
In case of a power outage recovery, your display will always start-up in the power mode
it was in before the power interruption (i.e. standby or on). This protects your display
against inadvertent image retention problems.
4.4 I-Luminate
About I-Luminate
When the display is in power on mode and the OSD menu is not shown, I-Luminate can be activated by
touching the
key.
I-Luminate supports three modes:
• Full-screen luminance boost.
•Film18x24mode.
•Film24x30mode.
For bo th film modes the position can be set to:
•Left
•Center
• Right
When touching the I-Luminate key, the display will enter the default I-Luminate mode, according to the
current setting, for approximately 1 minute. Touch the I-Luminate key again to immediately switch back
to normal mode.
While activated, the I-Luminate mode can be changed by using the
key.
The default I-Luminate mode can be s et in the OSD menu. Please refer to "I-Luminate
default mode", page 27 for detailed instructions on how to do this.
The I-Luminate film position can be set in the OSD menu. Please refer to "I-Luminate
film position", page 27 for detailed instructions on ho
wtodothis.
4.5 RapidFrame
About RapidFrame
The RapidFrame feature, eliminating blurry artifacts and ghosting in multi-frame image sequences, does
not need any user interaction. After starting up, RapidFrame will reach full effectiveness after the display
warms up.
K5902035 MAMMO TOMOSYNTHESIS 07/12/2017
21
To Next Page
Loading...
