5. Advanced operation
5.11 I-Luminate default m ode
About th e I-Luminate default mode
The I-Luminate mode defi nes the default activated mode during the I-Luminate boost. This mode can be:
Screen
The boost mode is applied on the screen display.
Film (large or small) Film (large or small): the boost mode activates a
high illuminated rectangle on top of the screen,
simulating a light box for use with radiological film.
The size of this rectangle is similar to a classic
(large or small) radiological film.
To set the I-Luminate mode:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > I-Luminate menu.
3. Enter the Default mode submenu.
4. Select Screen/Small Film/Large Film as desired and confirm.
5.12 I-Luminate film po sition
About the I-Luminate film position
By default, the I-Luminate rectangle comes up in the top/center of the screen. This position can be changed
to top/left or top/right corner.
To set the I-Luminate film position:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > I-Luminate menu.
3. Enter the Film Position submenu.
4. Select Left/Center/Right as desired and confirm.
5.13 Luminance target
About the luminance target
The luminance target of your Mammo Tomosynthesis is adjustable over a predefined range. When you
change the luminance target, the display will adjust i ts backlight to reach the target.
To set the luminance target:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Calibration menu.
3. Enter the Luminance Target submenu.
4. Set a luminance target value as desired and confirm.
The default, factory DICOM calibrated luminance value is available in the technical spec-
ifications table. The guaranteed ba cklight lifetime is valid for this setting.
K5902035 MAMMO TOMOSYNTHESIS 07/12/2017
27
To Next Page
Loading...
