K5902142 /04 Nio 5MP24
4.7 Hibernate
About hibernate
When hibernate is enabled, not only the backlight, but also other functions will be disabled to reduce power
consumption to a minimum. This happens after an adjustable period of time.
DPMS mode must be enabled before hibernate can be enabled. See “DPMS mode”, page 23.
Connect your keyboard, mouse, touchpad, etc. directly with your workstation (and not with the
display) to be able to awake your workstation and display from hibernate.
To enable/disable hibernate
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Hibernate submenu.
4. Select Enabled/Disabled as desired and confirm.
To adjust the hibernate time-out
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Hibernate Timeout submenu.
4. Set the time-out value as desired and confirm.
4.8 Dry mode
About Dry mode
Dry mode prevents condensation from forming in the display.
• In DPMS mode, the backlight remains powered at a minimum level to maintain some heat in the panel.
• When returning from DPMS mode, standby mode or off state, the display fans spin fast for 1 hour to
increase airflow in and around the display. After 1 hour, the fan speed returns to normal regime.
Dry mode remains enabled until manually disabled.
To enable/disable Dry mode on your display:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Dry Mode submenu.
4. Select Enabled/Disabled as desired and confirm.
Advanced operation
To Next Page
Loading...
