25K5902142 /04 Nio 5MP
4.9 Quick Dry mode
About Quick Dry mode
Quick Dry mode prevents condensation from forming in the display. Immediately after Quick Dry mode is
enabled, the display fans spin fast for 1 hour to increase airflow in and around the display. After 1 hour, the fan
speed returns to normal regime and Quick Dry mode is disabled again.
Quick Dry mode is always automatically disabled after it has run 1 time.
To enable/disable Quick Dry mode on your display
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Quick Dry Mode submenu.
4. Select Enabled/Disabled as desired and confirm.
4.10 Luminance target
About the luminance target
The luminance target of your Nio 5MP is adjustable over a predefined range. When you change the luminance
target, the display will adjust its backlight to reach the target.
To set the luminance target:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Calibration menu.
3. Enter the Luminance Target submenu.
4. Set a luminance target value as desired and confirm.
The default, factory calibrated luminance value is available in the technical specifications table. The
guaranteed backlight lifetime is valid for this setting.
4.11 Viewing modes
About viewing modes
The Nio 5MP can be used in two viewing modes:
• Diagnostic: This mode provides the full calibrated luminance and is intended for using the display for
diagnostic purposes.
• Text: In this mode, the luminance is reduced to approximately half of the luminance. This is intended for
using the display with office applications such as word processing.
Please note that text mode is not persistent. Once powered off, the display will restart in diagnostic mode.
The diagnostic mode should always be selected when the Nio 5MP is intended to be used in a
diagnostic environment.
To select a viewing mode
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Calibration menu.
Advanced operation
To Next Page
Loading...
