K5902142 /04 Nio 5MP32
3. Enter the Image Source Selection submenu and select Expert.
4. Enter the Input 1 or Input 2 Image Source submenu and select one of the image sources.
4.20 Grayscale conversion modes
Your Nio 5MP display automatically detects the connected video input signals and applies the
correct grayscale conversion settings. Manually selecting a grayscale conversion mode is possible,
but then your display’s image source selection mode should be set to allow this. Please refer to
“Image source selection”, page 30 to do this.
About grayscale conversion modes
Grayscale conversion modes specify how color generated on the display controller is converted to grayscale
in your display.
The available grayscale conversion modes are:
• No conversion
• Use red channel: This mode is intended for grayscale displays where gray is sent over the red channel.
• Use green channel: This mode is intended for grayscale displays where gray is sent over the green
channel.
• Use blue channel: This mode is intended for grayscale displays where gray is sent over the blue channel.
To manually select a grayscale conversion mode:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources > Input Settings > DisplayPort 1/2, DVI 1/2 menu.
3. Enter the Grayscale Conversion submenu.
4. Select one of the available color conversion modes and confirm.
4.21 EDID format
About EDID format
The Nio 5MP supports two EDID formats: E-EDID V1.4 and DisplayID V1.3
To select the EDID format
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources > Input Settings menu.
3. Enter the EDID format submenu.
4. Select one of the available format and confirm.
4.22 EDID timings
About EDID timings
Following EDID timings are available for your Nio 5MP:
• Resolution: Allows to manually modify the resolution of the image source video input signal.
• Refresh rate: Allows to manually select the refresh rate of the image source video input signal depending
on the maximum refresh rate of the display controller connected to your display.
• Color depth: Allows to change the color depth to 8 or to 10 bit (only when using DisplayPort input).
Advanced operation
To Next Page
Loading...
