Barco MDSC-8255 - Picture in Picture Transparency; Configuration Menu; Information; Language

K5902133 (451920612483)-02 MDSC-8255
38
5.3.9 Picture in Picture transparency
About Picture in Picture transparency
The available Picture in Picture transparencies range selectable for your display is between:
• 0: No transparency
• 10: Maximum transparency (roughly 37%)
To select Picture in Picture mode
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the PiP transparency submenu.
4. Select one of the required PiP transparency value and confirm.
5.4 Configuration menu
5.4.1 Information
About information
The available information items for your display are:
• Model (commercial type identification)
• SW package (display firmware identification)
• Main board release (hardware and firmware identification)
• MNA release (firmware identification)
• Eth1 Main (IP address of Main ethernet (1) port of the monitor)
• Eth2 2nd (IP address of 2nd ethernet (2) port of the monitor)
• Keyboard release (hardware and firmware identification)
• SDI module release (hardware and firmware identification)
• Serial Number (unit serial number)
• Main FPGA release (firmware identification)
To access information
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the Information submenu.
5.4.2 Language
About languages
The available languages for your display OSD menu are:
• English
• Français
• Deutsch
• Español
• Italiano
To select the language
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the Language submenu.
4. Select one of the available languages and confirm.
Advanced operation