Bard Site-Rite 6 - Software Upgrade Process

28
Site~Rite
*
6 Ultrasound System
8 Upgrading Software
The Site~Rite* 6 Ultrasound System allows the software to be upgraded through the USB connectors located
on the rear of the scanner.
To install software:
1. Press the Freeze button ( ) to pause the system.
2. Insert the USB drive containing the software upgrade into one of the USB connectors located on the
rear of the Site~Rite* 6 Ultrasound System scanner.
3. Waituntilthestoragedeviceiconisilluminatedbeforeproceeding.
4. Simultaneously press and hold the Gain buttons ( ) until the configuration screen appears.
5. When the configuration screen appears, simultaneously press and hold the Depth button ( cm ) and
Depth Marker button (
/:\
) until the software installation process begins.
Note: The Site~Rite* 6 Ultrasound System will automatically upload the software from the attached
USB drive.
Note: The screen may appear blank and/or inactive during part of the software installation process.
6. When the system displays a message that the software update is successful, power off the Site~Rite* 6
Ultrasound System scanner.
7. Disconnect the USB drive.
8. Power on the Site~Rite* 6 Ultrasound System scanner.
9. Verifythatthecorrectsoftwareversionappearsontheupperlefthandcornerofthescreen.
10. Resume normal operation.
,