BARIX Instreamer - Netmask

User Manual “Instreamer“ - V3.17 - 25th July 2011
The automatic options are as follow:
• “0.0.0.0” for automatic discovery (Discovery order:
BOOTP, DHCP, IPzator, AutoIP)
To enable automatic discovery but disable certain IP
discovery functions set all but the third value to zero.
For each function you want to disable add the value
from the table below:
• “0.0.1.0” to disable AutoIP
• “0.0.2.0” to disable DHCP
• “0.0.4.0” to disable BOOTP
• “0.0.8.0” to disable IPzator
Examples:
• “0.0.3.0” disables AutoIP and DHCP
• “0.0.11.0” disables all but BOOTP
Attention: “0.0.15.0” disables all discovery
functions which locks you out unless you reset the
device to factory defaults by pressing the reset
button for about 10 seconds.
Netmask
Enter the 4 values of the desired Netmask e.g.:
• “0.0.0.0” for a default Netmask depending on the
IP Address used
• “255.255.255.0” for a C class network
Note: Try first the Netmask your PC is set to or ask
your Network Administrator.
Device Configuration 17