User Manual “Instreamer“ - V3.17 - 25th July 2011
Port #
Enter the port number for each destination (between
0 and 65535). If this port is set to 0 then the default
ports are used (Internet Radio 80, TCP 2020, UDP
3030). For Shoutcast, enter the base port (the lower
one, the same as clients put into their radio players).
SNMP settings
SNMP settings are located in the streaming section
and are for advanced users only. Different SNMP
traps can be generated depending on the state of the
Barix Instreamer. The traps are triggered according
to specific audio values as described below. Note
that audio levels can only be monitored for analogue
audio inputs.
Trap Target IP Address
Enter the IP address of the SNMP trap destination.
Low Audio Level
Define the low audio level for the trap which will be
generated as soon as the audio level goes below this
value (and the “Silence timeout” has expired).
High Audio Level
Define the high audio level for the trap which will be
generated as soon as the audio level goes above
this value.
Trap Repeat
Define the SNMP trap repeat interval. The trap is
repeated if the audio level values are still out of
range.
Silence Timeout
Define the time interval for sending a trap after the
low audio level is detected.
32 Device Configuration
To Next Page
Loading...
