User Manual “Instreamer“ - V3.17 - 25th July 2011
3.2 Audio settings
This chapter explains how to adjust the audio input
and output settings of the Barix device.
Input source
Choose the desired input source. Line mono and
MIC input are mono, the other settings are stereo.
The options available depend on the HW according
to the table below.
The Exstreamer 500 and Exstreamer 1000 have
external Analogue to Digital circuitry which support
input speeds of 32 and 48kHz. The selection
provides a better input signal to noise ratio, however
the A/D gain is fixed and cannot be adjusted.
Default setting is "Line stereo".
Instreamer Ex 500 Ex 1000
Ann
100/200
Ann
1000
Ann 155
Line Mono Line Mono Line Mono Line Mono Line Mono -
Line Stereo Line Stereo Line Stereo -
Line
Stereo
-
- - - MIC MIC MIC
SPDIF optical - AES-EBU - - -
SPDIF coaxial
(MPEG input)
Line Ext
ADC
Line Ext ADC - - -
Device Configuration 19
To Next Page
Loading...
