Basic
safety instructions
POLARIS BASIC - for Zone 1/21
POLARIS Panel PCs 5.7" / 10.4" / 12.1"
EN 4/45
Technical data subject to change.
06/2017
1.6.2 Servicing
No constant servicing will be necessary if operated correctly under consideration of the
assembly instructions and environmental conditions. See Chapter "Service, inspection,
repair" in this respect.
1.6.3 Inspection
According to EN/IEC 60079-17 and EN/IEC 60079-
19, the operator of electrical
systems in potentially explosive atmospheres is obliged to have these inspected by an
electrician to ensure correct condition.
1.6.4 Repairs
Repairs to explosion-proof equipment may only be performed by persons authorized by
BARTEC, who must employ the latest technological practices, observe the
manufacturer's instructions and use only original spare parts. The applicable
regulations are to be observed here.
1.6.5 Commissioning
It
must be checked that all components and documents are available before
commissioning.
1.7 Labelling, test certificate and standards
The device features an explosion protection label, as well as a test certificate. For an
explanation of the symbols and information used, see chapter 4 "Technical data".
The POLARIS BASIC series complies with Directive 2014/34/EU on equipment and
protective systems intended for use in potentially explosive atmospheres (ATEX
Directive). For information on standards that must b
e observed, see chapter 3
"Explosion protection and approvals".
1.8 Warranty
WARNING
Explosion protection cannot be guaranteed if non-specified components are
used.
Do not make any changes or perform any reconstruction work on the device.
Use only original spare parts.
The manufacturer provides a full warranty exclusively for the spare parts it supplies.
When using parts from third parties, there is no guarantee that they have been designed
or manufactured to handle the requisite stress or offer the requisite degree of safety.
To Next Page
Loading...
Need help?
General
