11-85G5-7D0002/B-EHT-10/2021 23
12. Maintenance
CAUTION!
Risk of injury from electric shock
Disconnect the device from the power supply before
installation!
Observe the five safety rules!
The RLA
net
product is suitable for permanent use and is maintenance-free.
However, BARTEC recommends subjecting the entire leakage system to an inspection at least once a year.
The SCR sensor cable and the PS/PSO point sensor are largely maintenance-free. BARTEC recommends checking the electrodes of
the PS sensors and the optics of the PSO sensors to ensure they are clean and free of grease. Clean the electrodes and the optics
with alcohol or a degreasing household cleaner.
If changes have to be made to the installed system, the notes on installation in Chapter 7 and the information on Modbus RTU
communication in Chapter 6 may have to be observed.
Note: If necessary, comply with the inspection intervals of the respective insurance company (building insurance, public liability
insurance).
13. Decommissioning, dismantling
CAUTION!
Risk of injury from electric shock
Disconnect the device from the power supply before
installation!
Observe the five safety rules!
– Detach the connection cable from the terminals and separate it from the connection socket
– Detach the device from the bracket and remove it.
Dismantle the leakage monitoring system in accordance with the applicable local occupational health and safety and environmental
regulations. Sort the components according to the materials. Recycle the components:
– Scrap metals
– Recycle plastic elements
– Other components according to material properties
Electrical scrap and electronic components are subject to hazardous waste treatment. The local municipal authority or special disposal
companies will provide information on an environmentally friendly disposal.
To Next Page
Loading...
Need help?
General
