Basler BIP2-XXXXc - 3.5 Motion Detection Parameters

Configuring the Camera AW00097209000
36 Basler IP Fixed Box Cameras
Overlay Position - Sets the position of the text overlay bar.
 Top Left = Place the text overlay bar at the top left of each streamed image.
 Bottom Left = Place the text bar at the bottom left of each image.
 Top Right = Place the text overlay bar at the top right of each streamed image.
 Bottom Right = Place the text bar at the bottom right of each image.
Overlay Size - Sets the size of the text in the overlay.
 Small = The text in the overlay will be 10 point type.
 Medium = The text in the overlay will be 15 point type.
 Large = The text in the overlay will be 20 point type.
 Scaled = The text in the overlay will be scaled to 1/15 of the stream AOI height.
Note that if the text overlay is longer than the image width, the trailing edge of the overlay will be
truncated.
Overlay Style - Sets the style of the overlay. This parameter applies across both overlays. If you
choose "Black" for overlay 1, the style for overlay 2 will also be "Black".
 Normal = The overlay will display black text on a white background bar.
 Inverted = The overlay will display white text on a black background bar.
 White = The overlay will display white text with no background bar.
 Black = The overlay will display black text with no background bar.
$fps$ = display the current frame rate for this stream.
$cpu$ = display the load on the camera’s CPU.
$SysInfo.ModelName$ = display the camera’s model name.
$SysInfo.FirmwareVersion$ = display the camera’s firmware version info.
$SysInfo.ManName$ = display the camera vendor’s name.
$SysInfo.Serial$ = display the camera’s serial number.
$SysInfo.MACAddress$ = display the camera’s MAC address.
$System.DateTimeFormat$ = display the current date/time format setting.
$Network.RxTraffic$ = display the current incoming network traffic level in
kilobits/s.
$Network.TxTraffic$ = display the current outgoing network traffic level in kilobits/s.
$Network.HostName$ = display the host name of the camera.
$image$ = display an overlay image in the current stream.