Batavus Hybride - Adjusting Batavus Ergo Matic 3 Handlebars

17
Adjust handle bars of Batavus Ergo Matic 36.4
Tilting of the stem/handle bars
1. Press the safely lock (A) and open the handle (B)
by moving it up. With this both the tilting of the
stem and the handle bars can be adjusted in one
operation.
2. Tilt the stem and the handle bars to the required
position.
Make sure that the handle bars are exactly in
the middle.
3. After having made the adjustment, close the handle
(B) until you hear a click.
Height of the stem
1. Press the safely lock (A) and open the handle (B)
by moving it up.
2. Tilt the stem in a horizontal position.
3. Loosen the expander bolt (C).
4. Tap the bolt down and loose with a plastic-headed
hammer. If necessary, use a board.
5. Set the height.
Watch the max. mark on the stem.
6. Tighten the expander bolt (C).
7. After having made the adjustment, close the
handle (B) until you hear a click.
Set the clamping force of the handle
Caution:consultthedealerwhenyounoticeanymovementinthehandlebarswhenget-
ting on or off the bicycle. The dealer can adjust the clamping force.
Adjust Hybrid model6.5
Tilting of the stem/handle bars
1. Loosen the bolt (A).
2. Tilt the stem and the handle bars (B) to the
required position.
Make sure that the handle bars are exactly in
the middle.
3. Tighten the bolt
B
A
1
C
B
A
AB
1