18
Height of the stem
1. Tilt the stem in a horizontal position, see above.
2. Loosen the expander bolt (A).
3. Tap the bolt down and loose with a plastic-headed
hammer. If necessary, use a board.
4. Set the height.
Watch the max. mark on the stem.
5. Tighten the expander bolt (A).
Adjust adjustable Aheadset6.6
Tilting of the handle bars
1. Loosen the socket screws (A).
2. Tilt the handle bars to the required position.
Make sure that the handle bars are exactly in
the middle.
3. Tighten the socket screws.
Tilting of the stem/handle bars
1. Loosen the bolt (A).
2. Tilt the stem and the handle bars (B) to the
required position.
Make sure that the handle bars are exactly in
the middle.
3. Tighten the bolt.
To Next Page
Loading...
