Baumuller SI4000 - Page 51

Commissioning
Operation Manual Safety I/O Terminals SI4000 / SO4000
Document no.: 5.08009.05
51
of 82
7
7.1.8.4 Configuration of the safety SI4000 Parameter in ProSafety
Figure 11: ProSafety
h Switch to „Bus Configuration“ with the mouse
and mark the „Local I/O module / SI4000“.
=> The field „Safety parameter“ will be opened.
Here you can configure the SI40
00 specific safety parameter
such as „Watchdog time“, „Activation test pulse“, and so on.