– 16 –
Multi-Step Recipes
Additional steps can be entered within the original recipe number. Up to four individual steps can be added
by the operator, each with different bake settings.
For example, Recipe 1 has temperature, bake, steam and delay time settings set by the operator. This is
known as Step 1. After the timer times out in Step 1, the oven automatically starts the programmed bake
settings in Step 2. The system continues with each step until all steps have been timed out.
1. With the oven in the OFF mode, press and hold the UP arrow in the STEPS section. While pressing
and holding the UP arrow, press the POWER ON OFF button for 3 seconds. When the beep sounds,
the oven is in recipe mode.
2. Press the RECIPE UP or DOWN arrows until the recipe number that is desired is displayed. The
Step 1 light is lit.
3. Press the TEMP UP or DOWN arrows to enter the desired temperature.
4. Set the Bake, Steam, Delay Fan and Vent settings:
• Press the UP or DOWN arrows next to BAKE TIMER to enter the desired time.
• Press the UP or DOWN arrows next to STEAM TIMER to enter the desired time. If no time is
needed enter 0.
• Press the UP arrow next to FAN DELAY to enter the desired time. If no delay is required leave
set at 0.
• Press the VENT button to vent the cavity for the entire time of the step. For vent button location
see illustration on page 8. Vent button is located in the lower right hand corner of the control
panel. When step is complete, vent will close.
5. Press the UP arrow in the STEPS section to advance to the next step within the recipe. The selected
step light is lit.
6. Repeat steps 3 and 4 above to set each step, if needed, in the program.
7. To store all the steps in the program, press the RECIPE UP or DOWN arrows to move to the next
recipe number, or press the POWER ON OFF button to exit the recipe mode.
To Next Page
Loading...
Need help?
General
