– 23 –
SETUP
NUMBER
SETUP ITEM DISPLAY
P26 Keypad Version
Connected
Select which keypad is installed.
0 = With Recipes and cooldown button, without jog function [default].
1 = With jog function button, without recipes and cooldown.
P27 Reserved The default value is 8.
ENERGY SAVING MODE
Set back
Set back mode provides the ability to dial down the set temperature of the oven automatically when it is
not being used, but needs to be in a standby mode for baking. When the oven is switched to set back
temperature, the heating system remains in standby mode until it reaches that temperature. This leads to
a reduction in the amount of energy used.
Parameter 17 (Temperature Setback Time) allows the user to set the desired time for the oven to sit idle
before dropping the temperature to the value entered in Parameter 18 (Setback Temperature). Adjust P18
to the desired setback temperature. A setting of 250°F is recommended to keep the steam system above
the water ash point.
Advanced
Advanced energy savings (Parameter 21) mode allows the user to use the features of “Setback” as well
as locking the time that the oven can be turned on or off. This will prevent the oven from being turned on
to early or left on overnight. Follow the instructions for P21 (Advance energy savings mode) to set the
oven for advanced energy savings mode.
The oven will automatically shut down at the pre-determined time, unless there is a bake in process.
If you need to operate the oven after the pre-determined shutoff time, turn the oven back on by pressing
the ON/OFF button and immediately set the Bake Timer to at least 30 minutes and press start. If the bake
timer has not been set to at least 30 minutes the oven will shut down.
NOTE: If you do not use the oven within 30 minutes, after timer counts down to 00:00, the oven will shut
down.
SHUTDOWN
NOTE: Before restarting a gas oven, the power switch and the gas burner valve must be off for a minimum
of 5 minutes.
1. Remove all remaining product.
NOTE: Vent can be used to evacuate steam from oven.
2. Allow the oven to cool, then press the POWER ON/OFF button. If desired, quicker cool down time
can be accomplished through the use of the COOL DOWN button.
3. Clean the baking chamber. See Cleaning.
4. For lengthy shutdowns, disconnect the main power and shut off the gas and water supply.
PERFORM LED DISPLAY TEST
1. Switch the oven into the off mode.
2. Press and hold the Vent button then press and hold the POWER ON OFF button until you hear a
beep and see the rst test pattern.
The test will cycle through various LED tests. After the test has completed, it shall go back to showing the
regular display along with the clock and it shall beep once.
To Next Page
Loading...
Need help?
General
