BayTech DS9 User Manual

DS-SERIES OWNER’S MANUAL
APPENDIX E
82
d. Replace the module (ensure the screws are fastened to connect chassis
ground) and return power to the unit. The LEDs will illuminate
during the self test sequence. When the LED lights go off, the unit has
reset.
e. Remove power from the unit once more. Remove the module,
and move Jumper JP4 back to the two pins that are closest to the
aluminum face plate on the module (RUN). Upon initiation of power,
the DS71 or DS71-MD2 module will resume default configurations.
Refer to Table 1 on page 2.
7. Restore power to the unit. The EPROM upgrade is complete.

BayTech DS9 Specifications

General

Brand	BayTech
Model	DS9
Category	Switch
Language	English