Operating instructions B-Series
Version 2.4, En Page 21 of 81 21-10-2005
3.4.5 Construction form
MC
Single block to 3 kW 230/400V.
From 4 kW 400/690V. (Single block is motor with special shaft and extension flange B14a or
B5)
MM
Single block single-phase 230V. Single block is motor with special shaft and extension
flange B14a or B5)
S
Free shaft end, with bearing support.
N
Standard pump, (Pump is provided with extension flange for a standard motor with B5
extension flange)
T
Tractor pump, left-turning. (only B300L).
R
PTO drive gear. (Pump provided with reduction or accelerating gear unit with splain
connection)
MP (1, 2
or 3)
Pump attached to vacuum pump MP (1, 2 or 3).
3.4.6 Drive gear
S/MC
Bearing support pump assembled with B3 motor on base.
N/MC
Standard pump assembled with B5 motor.
HA
Pump assembled with Hatz diesel engine.
DE
Pump assembled with Deutz diesel engine.
LO
Pump assembled with Lombardini diesel engine.
LI
Pump assembled with Lister diesel engine.
IS
Pump assembled with Isuzu diesel engine.
3.4.7 Elastomers
N
NBR.
Trade names: Perbunan
, Hycar, Buna-N, Butacril, ISRN Butakon-A.
v
FPM,
Viton
. Trade names: FPM, Fluorel, Technoflon.
Nd
EPDM.
T
Teflon.
Trade names: PTFE, Tuffrupp
,
K
FFKM,
Kalrez.
Trade names: Chemraz
.
X
Special.
3.4.8 Options
F
DIN Flanges.
FK
DIN Flanges stainless steel.
BI
Bronze rotor CuAl10Ni2Mn1, DIN 1.4408. Stainless steel 316 shaft.
BII
Bronze rotor CuAl10Ni2Mn1, wear plate CuAl10Ni2Mn1 and DIN 1.4408. Stainless
steel 316 shaft.
KI
DIN 1.4408. Stainless steel 316 rotor and shaft.
KII
DIN 1.4408. Stainless steel 316 rotor, wear plate and shaft.
Z
Zinc anodes.
Vr
Cooling channel seal provided with grease reservoir with a spring.
Or
Cooling channel seal provided with oil reservoir
SP
Purge line connection. (According to plan 2, 11, 12, 21 or 31)
M
Cutter.
W1
1 Channel rotor.
W2
1 Channel rotor DIN 1.4401. Stainless steel 316.
2
2-disc rotor.
4
4-disc rotor.
S2
Double wear plate.
S3
Filler plate and wear plate.
To Next Page
Loading...
Need help?
General
