Operating instructions B-Series
Version 2.4, En Page 23 of 81 21-10-2005
4 Installation
In this section we describe how the pump/pump unit must be installed.
•
general
•
receipt
•
transport and storage
•
intermediary storage
•
preservation inside
•
general operating instructions for centrifugal pumps
•
construction
•
place of installation
•
fire- and explosion-dangerous spaces
•
protection against extreme temperatures
•
base
•
setup
•
radial load of shaft end
•
direction of rotation
•
safety devices
4.1 General
In this section you can find the instructions for the installation of the pump/pump unit. Everyone
concerned with the setup of the pump/pump unit must have read these instructions before starting the
installation work.
Together with the instructions you will find useful and important information to enable you to install the
pump in the correct and safe way.
Not complying with the instructions in the operating instructions can c
the user and the environment and/or serious damage to the pump
or the pump unit.
BBA Pompen BV is not responsible for accidents or damage caused by not respecting the instructions in this
manual. In this case any entitlement to damage compensation also becomes inapplicable.
Always keep these instructions for use in the vicinity of the pump or pump (unit).
It is absolutely necessary that the marks applied to the pump or pump (unit) (e.g. the
arrow plate that indicates the direction of rotation) are complied with and kept
readable.
To Next Page
Loading...
Need help?
General
