Operating instructions B-Series
Version 2.4, En Page 26 of 81 21-10-2005
4.8 Place of installation
Make sure that the operating equipment for the pump/pump unit is always accessible and also remains so
during the operation of the machine. Make sure that the pump/pump unit is mechanically well shielded and
that it is installed without power connected.
4.8.1 Space around the pump
Keep sufficient space around the pump/pump unit to be able to operate, inspect, insulate and maintain it.
With the disassembly of the bearing support (Back pull out system) and the pump housing sufficient space
must be left at the front of the pump.
4.8.2 Installation outdoors
The pump/pump unit may only be installed outdoors when the construction of the pump/pump unit allows
this. The distance from the cooling-air inlet of the motor to the wall must be sufficient to ensure the
unimpeded supply of air. Installation in places where corrosion or erosion can occur or where there is much
dust must be avoided. The limit values of the electric motor concerning the insulation class and protection
class must be strictly respected. When electrical power is supplied from other side, the relative operating
instructions must be complied with.
Note the applicable protection class of the pump/pump unit.
4.8.3 Installation indoors
The space in which the pump/pump unit is placed must be sufficiently ventilated. A too high ambient
temperature or air humidity can unfavourably influence the operation of the motor. The distance from the
cooling-air inlet of the motor to the wall must be sufficient to ensure the unimpeded supply of air. Installation
in places where corrosion or erosion can occur or where there is much dust must be avoided. The limit values
of the electric motor concerning the insulation class and protection class must be strictly respected. When
electrical power is supplied from other side, the relative operating instructions must be complied with.
Note the applicable protection class of the pump/pump unit, such as for example with use of a high-pressure
sprayer.
Opening
without danger:
In the case of pumping volatile and/or dangerous liquids the
dangers of these substances must be taken into account when
opening.
Protection
against other
dangers:
In the case of hot liquids being pumped it is the responsibility of
the employer to warn against hot surfaces if employees can come
into contact with them.
To Next Page
Loading...
Need help?
General
