Operating instructions B-Series
Version 2.4, En Page 24 of 81 21-10-2005
4.2 Receipt
Check the pump/pump unit on receipt for any damage during transport, and check whether the dispatch
fully corresponds to the dispatch note. In the event of damage or if the dispatch is incomplete, this must be
immediately reported to the carrier. This must be immediately noted this on the freight documentation.
Extra point(s) for attention with ATEX pumps.
T1.
Make sure that the pump (unit) is mechanically well shielded during transport.
4.3 Transport and storage
With the movement of the complete pump/pump unit by crane,
the hoisting must belts must be applied by qualified persons
according to the prevailing rules for good hoisting practice.
The hoisting equipment and hoisting belts must be sufficiently
strong to move the pump (unit). The hoisting eye of the motor
may not be used for moving the pump/pump unit.
Because of the amount of available versions only general
instructions can be given here.
This is normally sufficient for experienced installation
technicians and competent transporters. When in doubt or if there
are questions, detailed information about the pump/pump unit can
be requested. See technical specifications B-Series.
Never proceed under loads to be moved. Only entrust the movement of the
equipment to personnel trained for that purpose.
Consult the technical information for weights, and use the correct transport and hoisting equipment to move
the pump. When hoisting fasten the straps as shown on the illustration (also see technical specifications B-
Series”).
To Next Page
Loading...