Operating instructions B-Series
Version 2.4, En Page 45 of 81 21-10-2005
7.6 Earthing
Provide the pump/pump unit with earthing with a sufficiently large diameter, see technical specifications
B-Series.
Extra point(s) for attention with ATEX pumps.
P8.
Ensure a connection between pump and ground (earthing).
7.7 Combustion motors
With use of a combustion motor in the pump (unit) the manual for this motor is part of the full delivery.
Make immediate contact with the supplier of your pump/pump unit if this manual is not present.
Irrespective of these instructions for use, with all combustion motors the following must be complied with:
• The local safety instructions.
• Guard the outlet for the combustion gases against inadvertent contact.
• The starter must be automatically disconnected when the motor is started.
• The maximum and minimum motor speed set by us may not be changed.
• Check the following before starting:
Coolant level motor.
Oil level water pump.
Oil level vacuum pump.
Are drainage points of the water pump closed?
Is the fuel tank full?
Check optional extras (e.g. the belts of motor and vacuum pump).
• Make sure that the motor meets the set requirements if the pump unit is used in an explosion-dangerous
environment:
Protection
against other
dangers:
In the case of hot liquids being pumped it is the responsibility of
the employer to warn against hot surfaces if employees can come
into contact with them.
Never run the motor in a closed space.
Never fill fuel while the motor is running.
Make sure you wear ear defenders, protective gloves and safety glasses.
To Next Page
Loading...
Need help?
General
