EasyManuals Logo

BBA Pumps B Series User Manual

Default Icon
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
Operating instructions B-Series
Version 2.4, En Page 61 of 81 21-10-2005
Malfunction Cause Possible solution
Pump becomes
warm and/or
seizes
Purge line is blocked Clean
Turning parts run against stationary parts Adjust and align as necessary
The bearings are worn Replace bearings
The shaft runs eccentrically with worn
bearings or poor alignment
Replace and align bearings
The turning parts are out of balance
(vibrating)
Find imbalance and remedy
Ineffective lubrication or insufficient
lubricant in the bearing housings,
possibly as a result of a leak; noticeable
at increased temperature
Follow service plan
Insufficient lubrication Follow service plan
The bearings are soiled Replace bearings, prevent dirt penetration
Rust formation in the bearings due to
penetrated moisture
Replace bearings, prevent pump coming
into contact and with moisture with large
temperature differences.
Malfunction Cause Possible solution
Drive unit is
overloaded
Wrong direction of rotation Change direction of rotation
The shafts are not precisely in line Align unit
Turning parts run against stationary parts Adjust and align as necessary
The bearings are worn Replace bearings
The shaft runs eccentrically with worn
bearings or poor alignment
Replace and align bearings
The turning parts are out of balance
(vibrating)
Find imbalance and remedy
Ineffective lubrication or insufficient
lubricant in the bearing housings,
possibly as a result of a leak; noticeable
at increased temperature
Follow service plan
Insufficient lubrication Follow service plan
The bearings are soiled Replace bearings, prevent dirt penetration
Rust formation in the bearings due to
penetrated moisture
Replace bearings, prevent pump coming
into contact and with moisture with large
temperature differences.
The number of revolutions is too high Reduce number of revolutions
There is a blockage in the suction line Clean
The liquid has a higher density than the
viscosity for which the pump is intended
Adapt temperature of liquid if possible.
Choose other pump

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BBA Pumps B Series and is the answer not in the manual?

BBA Pumps B Series Specifications

General IconGeneral
BrandBBA Pumps
ModelB Series
CategoryWater Pump
LanguageEnglish

Related product manuals