The Menus
bbe BenthoTorch Manual Page 46
It is possible to select more than one file by pressing the shift key while selecting the file.
FluoroProbe only: Afterwards choose how to apply the air pressure and hence the calculation of depth.
A
IR PRESSURE AS GIVEN IN FILE
(F
LUORO
P
ROBE AND
A
LGAE
T
ORCH
100
ONLY
)
Air pressure was measured at the beginning of the measurement. This value is used.
A
IR PRESSURE FROM FIRST DATA SET
(F
LUORO
P
ROBE AND
A
LGAE
T
ORCH
100
ONLY
)
The first measurement of air pressure took place in air. This is the appropriate selection if an autostart-plug
without a PC was used (for further information see the FluoroProbe-manual).
A
IR PRESSURE
(F
LUORO
P
ROBE AND
A
LGAE
T
ORCH
100
ONLY
)
Allows the entry of a constant value. To be used if the FluoroProbe was submerged for a longer time and unable
to measure the air pressure by itself.
In case of FluoroProbe data, the results are recalculated from the raw data after importing.
The calculation procedure takes place in subsequent steps. After importing all data, a success message is
shown.
To Next Page
Loading...