13
manual.
• EU Only: Users shall report any serious incident related to the device to the Manufacturer and National Competent Authority.
Outside EU: Contact your local BD representative for any incident or inquiry related to this device.
2 Installation
2.1 General
This section provides specifications for installation and setup of the BD Veritor™ Plus Analyzer, plus the optional BD Veritor™ barcode
scanning modules as well as the BD Veritor™ Plus Connect accessory. The following major topics are included:
• Analyzer Specifications
• Analyzer Setup
• Printer Setup
• Module Specifications
• Module Setup
2.2 Analyzer Specifications
WARNING
PROTECTION PROVIDED BY THIS EQUIPMENT MAY BE IMPAIRED IF THE EQUIPMENT IS USED IN A MANNER
NOT CONSISTENT WITH THE INSTRUCTIONS IN THIS MANUAL.
Physical Specifications
Length 14.3 cm
Width 9.0 cm
Height (including feet) 7.6 cm
Weight (Analyzer) 300 g
Weight (Analyzer and installed module) 350 g
Electrical Specifications
Supply
Voltage
The BD Veritor
™ Plus Analyzer is provided with an auto-switching power supply with recommended input of 100–240
VAC at 50–60 Hz, 0.6 A.
The Analyzer power requirement is 5.0 VDC ± 5%, 1,500 mA.
Environmental Specifications
Operating Conditions
To Next Page
Loading...
