11
BD Veritor™ InfoWiFi Module - Optional
The BD Veritor™ InfoWiFi module provides the same functional features as the BD Veritor™ InfoScan module and adds wireless
communication capability. Once configured, the BD Veritor™ InfoWiFi module can connect to a local wireless network and transmit test
results to the BD Synapsys
TM
Informatics Solution. An additional BD Synapsys™ Informatics subscription is required.A BD Veritor™ Plus
Analyzer configured with a BD Veritor™ InfoWiFi module can be identified by the label on its underside, shown in the image below.
1.4 Principles of the Procedure
The BD Veritor™ Plus Analyzer is an optoelectronic instrument that uses image processing and a specific algorithm to determine the
presence or absence of any target analyte(s).
The BD Veritor™ Plus Analyzer detects the insertion of a BD Veritor™ Test Device and reads the device barcode to detect the assay type.
Once it registers the test type, the Analyzer uses a reflectance-based measurement method to evaluate the line signal intensities on the
assay test strip. The Analyzer determines the line intensity at each of the spatially-defined test and control line positions, interprets the
results using a scoring algorithm, and reports a positive, negative, or invalid result based on pre-set thresholds. A liquid crystal display
(LCD) on the instrument communicates status and results to the operator.
Because the BD Veritor™ Plus Analyzer and Test Devices are designed as an integrated system, it is not possible to replicate the result
determination visually. Therefore assay result determination by operator visual readings of the BD Veritor™ System Test Devices is not
recommended.
The instrument is maintenance-free and is configured with a single button design (power switch) for ease of operation.
1.5 Use of this Manual
This manual is designed as an integral part of instrument operation for trained laboratory personnel, technologists, supervisors, and other
personnel who operate the BD Veritor™ Plus Analyzer instrument on a regular basis. Every attempt has been made to include all
information that would be required during normal use and maintenance of the system. Should a question arise which is not answered in this
manual, please contact the following parties:
Technical Service and Support: In the United States contact BD at 1.800.638.8663 or bd.com.
For regions outside of the United States, contact your local BD representative or bd.com.
Comments or recommendations on this manual may be expressed via e-mail to LabelingDD@bd.com.
1.6 Conventions
1.6.1 User Interface
System prompts and messages are shown in CAPITAL LETTERS (e.g., INSERT TEST DEVICE).
To Next Page
Loading...
