To Next PageTo Next PageWhat to do if my BEA Door Opening System cycles open and remains open?
If your door cycles open and remains open, it might be due to the door control monitoring being set to Active High. Set the door control monitoring to Active Low. It could also be that the safety output is set incorrectly; set the safety output required for the door control.
What to do if BEA Security Sensors signals an internal fault?
If your BEA Security Sensor signals an internal fault, cycle the power supply. If the orange LED flashes again, replace the sensor.
What to do if the LCD or remote control of BEA Accessories does not react?
If the LCD or remote control does not react, it might be because the BEA Accessories sensor is protected by a password. Enter the correct password. If you've forgotten the password, cut and restore the power supply to access the sensor without needing to enter a password for one minute.
What to do if RED LED flashes during the assisted setup of BEA IXIO-ST?
If the RED LED flashes during the assisted setup, it could be because the sensor detects the door too quickly after the setup. To resolve this, try the following: * Move the IR-curtains away from the door. * Install the sensor as close to the door as possible. * Launch a new assisted setup.
What to do if my BEA Door Opening System sensor does not respond to the remote control?
If the sensor does not respond to the remote control, the batteries may be dead. Replace the batteries.
What to do if I cannot access the LCD menu or change parameters via remote control on my BEA Door Opening System?
If you cannot access the LCD menu or change parameters via remote control, the sensor may be protected by a password. Enter the correct password. If you forgot the code, cut and restore the power supply to access the sensor without entering a password during 1 minute.
How to unlock BEA Door Opening System if the LCD or remote control does not react?
If the LCD or remote control of your BEA Door Opening System isn't responding, it might be because the sensor is password protected. Try entering the correct password. If you've forgotten the password, cut and restore the power supply to access the sensor without needing a password for one minute.
What does it mean when the orange LED flashes 8 times on my BEA Door Opening System?
If the orange LED on your BEA Door Opening System flashes 8 times, it indicates that the IR power emitter is faulty. The suggested solution is to replace the sensor.
What to do if BEA IXIO-ST sensor is disturbed?
If the BEA Accessories sensor is disturbed, increase the IR-immunity filter to value 3.
What to do if E4 ORANGE LED flashes 4 x on BEA Accessories?
If the E4 ORANGE LED flashes 4 times, it suggests that the sensor isn't receiving enough IR energy. Try the following: * Decrease the angle of the IR-curtains. * Increase the IR-immunity filter (values >2.8 m). * Deactivate 1 curtain.
Power| supply voltage | 12 V - 24 V AC, 50/60 Hz; 12 V - 30 V DC |
|---|---|
| power consumption | < 2.5 W |
| max contact voltage | 42 V AC/DC |
Operating Environment| mounting height | 6.5 ft to 11.5 ft |
|---|---|
| temperature range sensor | -31°F to +131°F |
| temperature range LCD | 14°F to +131°F |
Detection Technology| detection mode | Active infrared with background analysis |
|---|---|
| spot size | 5 cm x 5 cm |
| number of spots | max. 24 per curtain |
