BEALE AK160 - Setup; Power Supply

SETUP
You can power the instrument either by batteries or by the included
power adaptor. Follow the instructions described below.
Using Batteries
The instrument needs 6 pieces of AA size or equivalent alkaline
batteries for power supply.
1. Open the battery cabinet cover located on the bottom of
the instrument.
2. Insert the batteries, carefully following the polarity markings
on the cabinet.
3. Replace the cabinet cover. Make sure it locks rmly in place.
NOTES:
• Do not mix using any used and new batteries.
• Always use the same types of batteries.
• Remove the batteries when the instrument is not in use for a long
period of time.
Using the Power Adapter
1. Turn down the volume before connecting to power supply.
2. Connect the adaptor to the DC IN jack of the instrument.
3. Plug the adaptor into an AC outlet. This will automatically cut o
the battery power supply.
Note:
• In order to save energy, the instrument will automatically shut
down after 30 minutes if it is not used. (Please refer to Auto
Power O).
• For your safety, please unplug the instrument when it is not in
use or during a thunderstorm.
This section contains information about setting up your instrument and preparing to play. Please go through this section carefully before
turning the power on.
POWER SUPPLY
AK160
3