EasyManuals Logo

Beckhoff CU2508 User Manual

Beckhoff CU2508
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
Commissioning
Real-time Ethernet port multiplier38
Version: 2.6
Setting up EtherCAT cable redundancy
The EtherCAT configuration must be created on a CU2508 downlink port as described in the chapter "Setup:
Device EtherCAT [}32]". The resulting topology can be displayed in the Device EtherCAT using the Topology
button; see fig. Display of a simple EtherCAT topology.
Fig.47: Display of a simple EtherCAT topology
The items below are to be specified in the following steps
the control-side redundancy adapter, in this case on the CU2508
the field-side redundancy adapter on the last EtherCAT slave
The EtherCAT redundancy port is specified in Device -> EtherCAT -> Advanced Settings.
Fig.48: Specification of the redundancy port

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beckhoff CU2508 and is the answer not in the manual?

Beckhoff CU2508 Specifications

General IconGeneral
BrandBeckhoff
ModelCU2508
CategorySwitch
LanguageEnglish