If your Beco Air Conditioner isn't cooling sufficiently, several factors could be at play. First, ensure all doors and windows are completely closed. Remove any heat sources from the room. Check that the exhaust air hose is properly connected and not blocked; clean it if necessary. Also, verify that the temperature setting isn't too high and reset it if needed. Finally, make sure the air inlet isn't blocked; clean it if it is.
R
Richard LeeAug 17, 2025
What to do if Beco BP109C Air Conditioner does not start?
J
jbaileyAug 17, 2025
If your Beco Air Conditioner doesn't start when you press the on/off button, it could be due to a few reasons. If the water full indicator lamp is blinking, it means the water tank is full; empty it. Alternatively, if you're in heating mode, the room temperature might be higher than the set temperature, so reset the temperature. Conversely, in cooling mode, the room temperature could be lower than the set temperature; in that case, also reset the temperature.
G
garzaleslieAug 21, 2025
How to fix E2 code on Beco Air Conditioner?
K
keithmitchellAug 21, 2025
If your Beco Air Conditioner displays an E2 code, it indicates that the water tank is full during cooling. To resolve this, take off the rubber stopper and empty the water.
D
Diane GoodmanAug 25, 2025
Why is my Beco Air Conditioner so noisy?
N
Nathan HarrisonAug 25, 2025
If your Beco Air Conditioner is noisy, it could be due to a couple of reasons. Ensure the unit is placed on a flat, level surface. If the sound seems to be coming from inside the unit, it might be the refrigerant flowing, which is normal.
P
priscilla39Aug 29, 2025
What does E4 code mean on Beco BP109C Air Conditioner?
K
Kurt HowardAug 29, 2025
If your Beco Air Conditioner is showing an E4 code, it means the water tank is full when the unit is in heating mode. Please empty the water tank to resolve this issue.
A
Amy RasmussenSep 1, 2025
What does E0 error code mean on Beco Air Conditioner?
K
Karen MolinaSep 2, 2025
If your Beco Air Conditioner displays an E0 code, it indicates that the room temperature sensor has failed. You can replace the room temperature sensor, but the unit can still function without it.
J
James MillerSep 5, 2025
How to fix E1 error on Beco BP109C Air Conditioner?
L
Lauren McdonaldSep 5, 2025
If your Beco Air Conditioner displays an E1 code, it means the condenser temperature sensor has failed. Replace the condenser temperature sensor to resolve this.
J
James BrightSep 9, 2025
What does E3 error mean on Beco BP109C?
E
Eric HardingSep 9, 2025
If your Beco Air Conditioner shows an E3 code, it indicates a failure of the evaporator temperature sensor. Replace the evaporator temperature sensor to fix this problem.
To Next Page
General