GB Sound module USM-RC-3
38 BEIER-Electronic 11.10.2021
The possible playback modes are now described. They differ also in that way, how
the sound is started.
Triggering with proportional channels (as memory configured) or with EKMFA-
mode:
When the sound is started, it is played exactly once,
from start to finish, and then it stops. It is not possible to
halt the sound prematurely; it is always played
When the sound is started, it is played exactly once,
from start to finish, and then stops. However, if the
sound is started again while it is already or still running,
the sound is stopped immediately.
When the sound is started, it is played again and again
from start to finish in an endless loop. To switch the
sound off again it must be virtually “started” again. The
sound then runs from start to finish once more
completely, and then it stops.
When the sound is started, it is played again and again
from start to finish in an endless loop. To switch the
sound off it must be virtually “started” again. The sound
Triggering with proportional channels (as static configured), nautic-mode or
switching inputs:
When the sound is started, it is played exactly once,
from start to finish, and then it stops. It is not possible to
halt the sound prematurely; it is always played
When the sound is started, it is played exactly once,
from start to finish, and then stops. However, if the input
is switched off while it is still running, the sound is then
When the input is switched on, the sound is played
again and again from start to finish in an endless loop. If
the input is switched off again, the sound runs from start
to finish once more completely, and then stops.
When the input is switched on, the sound is played
again and again from start to finish in an endless loop. If
the input is switched off again, the sound then stops
To Next Page
Loading...