Beijer Electronics Frequency Inverter BFI-E3 KI00369B 2019-09
www.beijer.se www.beijer.no www.beijer.dk www.beijerelectronics.de www.beijerelectronics.com www.beijerelektronik.com.tr 2 (24)
3 Contents
1 START-UP DOCUMENT 1
2 IMPORTANT SAFETY INFORMATION 1
3 CONTENTS 2
4 INSTALLATION 3
4.1 PHYSICAL DIMENSIONS IP20 ...................................................................................................................................... 3
4.2 PHYSICAL DIMENSIONS IP66 ...................................................................................................................................... 4
4.3 FUSES, CABLE DIMENSIONS AND POWER LOSES ........................................................................................................ 5
4.4 OVERVIEW POWER INPUT AND OUTPUT TERMINALS .................................................................................................. 5
4.5 INSTALLATION OF POWER SUPPLY, GROUNDING AND MOTOR CABLE ........................................................................ 6
4.6 BRAKE TRANSISTOR AND EXTERNAL BRAKE RESISTOR ............................................................................................. 7
4.7 OVERVIEW CONTROL INPUTS/OUTPUTS ..................................................................................................................... 8
5 BASIC PARAMETER SETTING 9
5.1 DIGITAL START IN 2 DIRECTIONS AND 4 FIXED PRESET SPEEDS ............................................................................... 9
5.2 DIGITAL START IN 2 DIRECTIONS AND ANALOG FREQUENCY SET POINT .................................................................. 10
5.3 DIGITAL MOTOR POTENTIOMETER ............................................................................................................................ 10
5.4 DIGITAL START SIGNAL AND FREQUENCY SET POINT BY LED DISPLAY ................................................................... 11
5.5 START/STOP BY INDIVIDUAL SIGNALS ....................................................................................................................... 11
5.6 CONTROL FROM LED DISPLAY ................................................................................................................................. 11
5.7 ANALOG OUTPUT, 0-10 VDC ................................................................................................................................... 12
5.8 DIGITAL OUTPUTS ..................................................................................................................................................... 12
5.9 STYRNING AV MEKANISK HÅLLBROMS I MOTORN ..................................................................................................... 12
5.10 PTC-THERMISTOR .................................................................................................................................................... 12
5.11 VECTOR CONTROL WITH STANDARD INDUCTION MOTOR ......................................................................................... 13
5.12 CURRENT LIMIT CONTROL......................................................................................................................................... 13
5.13 TUNING OF PM-MOTOR ............................................................................................................................................ 13
5.14 MODBUS RTU .......................................................................................................................................................... 14
5.15 CANOPEN ................................................................................................................................................................. 15
5.16 PI-CONTROL ............................................................................................................................................................. 16
5.17 ENERGY OPTIMIZATION FUNCTION ........................................................................................................................... 16
5.18 SPIN START ............................................................................................................................................................... 17
5.19 BFI-SMARTSTICK...................................................................................................................................................... 17
6 KEYPAD 18
6.1 MONITORING FROM KEYPAD .................................................................................................................................... 19
6.2 IP66, MAIN SWITCH, START/STOP SWITCH AND POTENTIOMETER .......................................................................... 20
6.3 EMC-FILTER ............................................................................................................................................................. 20
7 SPECIFICATION 21
8 WARNING AND ALARM CODES 22
Copyright © Beijer Electronics, 2017
This software/documentation/information (below referred to as ‘the material’) is the property of Beijer
Electronics. The holder or user has a non-exclusive right to use the material.
The holder is not allowed to distribute the material to anyone outside his/her organization except in cases
where the material is part of a system that is supplied by the holder to his/her customer.
The material may only be used with products or software supplied by Beijer Electronics. Beijer Electronics
assumes no responsibility for any defects in the material, or for any consequences that might arise from the
use of the material.
It is the responsibility of the holder to ensure that any systems, for whatever applications, which is based on
or includes the material (whether in its entirety or in parts), meets the expected properties or functional
requirements.
Beijer Electronics has no obligation to supply the holder with updated versions.
To Next Page
Loading...
Need help?
General
