Beijer Electronics BFI-H3 - Parameters Factory Reset; User Reset; Selecting between Hand and Auto Control

Beijer Electronics Frequency Inverter BFI-H3 KI00363D 2021-07
www.beijerelectronics.com 25 (32)
6.4 Parameters Factory Reset / User Reset
BFI-H3 provides a feature to allow the user to define their own default parameter set. After
commissioning all required parameters, the user can save these as the default parameters by setting
P6-29 = 1. If required, the User Default Parameters may be cleared by setting P6-29 = 2.
If the user wishes to reload 'Factory Defaults' parameters to the drive memory, then follow the
procedure shown below left.
If the user wishes to reload their own pre-saved 'User Defaults' parameters to the drive memory,
then follow the procedure shown below-right.
NOTE! If no User Default parameters have been saved in the drive, carrying out the User Parameter
Reset procedure will return the drive to Factory Defaults.
6.5 Selecting between Hand and Auto Control