Beko BEHPH 090 - Freezing protection; Lock function; Turbo function

18 / 56 EN
Remote Control / User Manual
7 How to use advanced functions
7.7 Freezing protection
x2
The unit will operate at high fan speed (while
compressor on) with temperature automatically
set to 8°C/46°F.
C
This function is for heat pump air
conditioner only.
Press this button 2 times during one second under
HEAT Mode and setting temperature of 17°C/62°F
to activate FP function.Press On/Off, Sleep, Mode,
Fan and Temp. button while while operating will
cancel this function.
7.8 Lock function
5s
5s
Turbo
+
Self
Clean+
Press together SelfClean+ button and Turbo button
at the same time more than 5 seconds to activate
Lock function. All buttons will not response except
pressing these two buttons for two seconds again
to disable locking.
7.9 Turbo function
Press TURBO button
Turbo
When you select Turbo feature in COOL mode, the
unit will blow cool air with strongest wind setting
to jump-start the cooling process.
When you select Turbo feature in HEAT mode,
for units with Electric heat elements, the Electric
HEATER will activate and jump-start the heating
process.