47
G+ MIMO Wireless Modem Router
SECTIONSTable of Contents 1 2 3 4 5 7 8 9 106
USING THE WEB-BASED ADVANCED USER INTERFACE
Setting WPA/WPA2-Personal (PSK)
Like WPA security, WPA2 is available in WPA2-Personal (PSK) mode�
Typically, WPA2-Personal (PSK) is the mode that will be used in a home
environment� Please refer to the User Manual for more information about
wireless security and different types of wireless security�
1. After you’ve set up your Router, go to the “Security” page under
“Wireless” and select “WPA/WPA2-Personal (PSK)” from the
“Security Mode” drop-down menu�
2. For “Authentication”, select “WPA-PSK”, “WPA2-PSK”, or “WPA-
PSK + WPA2-PSK”� This setting will have to be identical on the
wireless clients that you set up� “WPA-PSK + WPA2-PSK” mode
will allow the Router to support clients running either WPA or WPA2
security�
3. For “Encryption Technique”, select “TKIP”, “AES”, or “TKIP+AES”�
This setting will have to be identical on the wireless clients that you
set up�
4. Enter your pre-shared key (PSK)� This can be from eight to 63
characters and can be letters, numbers, or symbols� This same
key must be used on all of the wireless clients that you set up� For
example, your PSK might be something like: “Smith family network
key”� Click “Apply Changes” to finish� You must now set all wireless
clients to match these settings�
IMPORTANT: Make sure your wireless computers are updated
to work with WPA2 and have the correct settings to get proper
connection to the Router�
To Next Page
Loading...
