Belkin G+MIMO - Page 77

75
G+ MIMO Wireless Modem Router
SECTIONSTable of Contents 1 2 3 4 5 6 8 9 107
MANUALLY CONFIGURING NETWORK SETTINGS
Manually Configuring Network Adapters in Windows 98 or Me
1. Right-click on “My Network Neighborhood” and select “Properties”
from the drop-down menu�
2. Select “TCP/IP -> settings” for your installed network adapter� You
will see the following window�
3. If “Specify and IP address” is selected, your Router will need
to be set up for a static IP connection type� Write the address
information in the table below� You will need to enter this
information into the Router�
4. Write the IP address and subnet mask from the “IP Address”
tab (3)�
5. Click the “Gateway” tab (2)� Write the gateway address down in
the chart�
6. Click the “DNS Configuration” tab (1)� Write the DNS address(es)
in the chart�
(1)
(3)
(2)
7. If not already selected, select “Obtain IP address automatically” in
the “IP Address” tab� Click “OK”�
Restart the computer. When the computer restarts, your network
adapter(s) are now configured for use with the Router.