Bematech S302D User Manual

Advanced imaging barcode scanner
2
PROGRAMMING GUIDE
Interface Mode
Interface Switch
The S302D imaging barcode scanner supports USB virtual COM, USB-HID and RS232. The
USB cable supports both USB virtual COM and USB-HID modes. Please install the virtual
COM port driver before using USB Virtual COM.
 To use USB Virtual COM for the first time, scan the USB Virtual COM
barcode below and then install the Virtual COM driver.
 To switch from USB Virtual Com to USB-HID mode after the virtual COM
driver is installed, scan the USB HID barcode below.
 To switch from USB Virtual Com to USB-HID mode if the virtual COM driver
is not installed:
1. Unplug USB cable from computer.
2. Press and hold the trigger while plugging USB cable to computer.
3. Scan the USB HID barcode below.
 To switch to RS232, change to RS232 interface cable, then scan barcodes on
next few pages to set up communication protocols.
USB HID
(Default)
USB Virtual COM

Bematech S302D Specifications

General

Brand	Bematech
Model	S302D
Category	Barcode Reader
Language	English