11Bend-Tech Dragon
Material Coolant System Assembly
02
Material Coolant System Assembly Manual
2.2.3 Leveling Feet
Locate the Leveling Feet in the hardware bag. Thread a nut onto each leveling foot, leaving
about an inch between the base of the foot and the nut. Insert a Leveling Foot into the hole at
the bottom of each Aluminum Support Leg.
Thread a second nut
onto the Leveling
Foot after inserting it
in the mounting hole
on the bottom of the
Aluminum Support
Leg. Do not tighten.
Leave space for
adjustment of the
support legs.
2.2.4 Parts Catcher
Place the parts catcher on the Beak at
the Head of the machine, just in front
of and under the Gate opening.
Locate eight ¾ in. button head screws,
nuts and washers from the hardware
bag. Insert the eight fasteners through
the slotted opening in the Parts
Catcher, aligning them with the holes in
the Beak.
Ensure the screw heads are on the
outside of the assembly and the nuts
and washers are on the inside. Thread
the nuts on and snug them down. Do
not tighten the nuts at this time.
Bend-Tech recommends enlisting a helper when assembling the Water Tray System.
Head of Machine
Parts Catcher
4 Bolts
per side
Leveling Feet
To Next Page
Loading...
Need help?
General
